Bug-o-systems UNI-BUG III Uživatelský manuál stáhnout pdf (Strana 9)

CONTROLS, CONT’D.

LCD DISPLAY: Displays the programming parameters such as travel speed, skip

length, crater ll, and weld length.

TRAVEL SPEED: Used to adjust the travel speed of the machine.

INCREASE BUTTON: Increases the numerical value of the selected parameter.

DECREASE BUTTON: Decreases the numerical value of the selected parameter.

ENTER BUTTON: Enters the set value into memory and toggles you to the next parameter.

SKIP LENGTH: When selected enter the value of the length of the skip distance.

CRATER FILL: When selected enter the value of the crater ll time.

WELD LENGTH: When selected enter the value of the length of the weld.

TRAVEL DIRECTION: Dictates which direction the machine will travel. Must be in the “OFF”

position to program parameters.

SKIP / CONTINUOUS: Used to select either the skip or continuous welding operation.

CIRCUIT BREAKER: Provides overload protection for the machine.

POWER ON / OFF: Turns power on and off to the machine.

WELD CONTACT I: If using one welding gun, switch weld contact 1 to the “ON” position.

WELD CONTACT II: If using two welding guns, both weld contact 1 and 2 should be switched

to the “ON” position.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Žádné komentáře

Bug-o-systems UNI-BUG III Uživatelský manuál Strana 9